1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + LibreELEC 2 LEDs out of 186 stay lit

Discussion in 'Software Support' started by Duncan, 6 August 2018.

  1. Duncan

    Duncan New Member

    Messages:
    4
    Hardware:
    RPi1/Zero, RPi2
    I have a Raspberry Pi 2 with 186 lpd8806 LEDs attached.

    All was running well and then the SD card died after years of use, to be expected sometimes.

    I rebuilt the system with a new SD card running Hyperion on top of Libreelec.

    The last 2 LEDs stay full on (white) at all times even if I "tell" them all off or all red or green etc. and even when there is no signal.

    Any ideas? The setup was fine in the past running on Openelec and running on Libreelec when I first switched.

    Any info I should provide? Is there a way to individually address specific LEDs?

    json attached is that helps.

    Cheers
     

    Attached Files:

  2. st0n3rd

    st0n3rd New Member

    Messages:
    10
    Hardware:
    RPi3
    have you tried adding two extra leds to your config just to see if they change ? idk what that helps but youcould do that and a 2 led gap at the bottom if theyre on the bottom
    otherwise id try another power supply or connect both ends of the strip to power