1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

HyperCon Config File Questions

Discussion in 'Software Support' started by Drew, 9 December 2016.

  1. Drew

    Drew New Member

    Messages:
    3
    Hardware:
    RPi3, 32/64bit
    hello,
    i set up my ambilight with a rpi 3 and 118 ws2801 leds. I Installed hyperion through the ssh of the hypercon app, and all is good until i make the config file. It seems I cannot get the file to the rpi. When I go to send the config i get

    sftp Send Hyperion Config - Sourcepath: , Targetpath: /etc/hyperion/, Filename: hyperion.config.json

    but when I go to run hyperion it says no config file is in the pi

    Any help would be greatly appreciated.
     
  2. TPmodding

    TPmodding Administrator Staff Member Administrator

    Messages:
    1,339
    Hardware:
    RPi1/Zero, RPi2, RPi3, +Arduino, +nodeMCU/ESP8266
    have you linux know-how? create the config file and transfer it with filezilla, this should be work better