1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

BUG Hypercon 1.0.3.1 Save settings

Discussion in 'Bug Reports' started by jjansen, 18 June 2016.

  1. jjansen

    jjansen New Member

    Messages:
    21
    Hardware:
    RPi2, RPi3, +Arduino, +PhilipsHue, +nodeMCU/ESP8266
    Not sure if this is the same known issue as "Device settings are not loaded from persistent (.dat)"...

    Device configuration is not being saved (or loaded) by hypercon. I always have to enter the output port and baudrate again. Other settings seems to be saved correctly.
     
  2. Brindosch

    Brindosch Active Member

    Messages:
    678
    Hardware:
    RPi1/Zero, RPi2, RPi3, +nodeMCU/ESP8266
    Greetings,
    yes it is. A very annoying issue.