1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SOLVED Issues Getting Hyperion to Install/Run

Discussion in 'Software Support' started by Nikhil, 9 March 2017.

  1. Nikhil

    Nikhil Member

    Messages:
    30
    Hardware:
    RPi3, +Arduino, +PhilipsHue
    1. What driver are you using? SPI, PWM, Adalight?
    2. What is the amperage limit for your power supply?
    3. Have you tried a 100ohm resistor instead of the 270ohm?
     
  2. episcop

    episcop New Member

    Messages:
    4
    Hardware:
    RPi3, +Arduino
    1. With arduino - adalight, direct - ws281x.(into HyperCon)
    2. Power suplay 5A for strip, and 2A for Rpi3.
    3. Try direct, lewel shifter, 220ohm.
    On LE&osmc need edit config.txt?
     
  3. episcop

    episcop New Member

    Messages:
    4
    Hardware:
    RPi3, +Arduino
    Solved. My errors: when using PWM driver direct gpio - have HDMI unpluged, output have noise(looking oscilogramme). After, using arduino and sketch from this forum. Work only test color via ssh. Grabber external not working, because in HyperCon grabber tab internal box cheked & have priority of external. After configuration all ok.