1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

SOLVED Kodi connection problem

Discussion in 'Software Support' started by japetus, 5 November 2016.

  1. japetus

    japetus New Member

    Messages:
    4
    Hardware:
    RPi1/Zero, RPi2, RPi3
    Hi, I was using a custom built ws2811 50-led string array with arduino connected via usb to my old raspi b+ running openelec and worked fine on two identical hardware led tv setups.
    I recently tried to use the same setup with a rpi2 running libreelec and it didn't work. I used the same old .json file and the device is correctly connected at ttyUSB0. I get the initial rainbow effect and for a moment blue leds corresponding to kodi home screen and then connection is lost and the leds our out.
    I enclose log and my .json config..


    hyperion.config.json:
     
  2. japetus

    japetus New Member

    Messages:
    4
    Hardware:
    RPi1/Zero, RPi2, RPi3
    Tried it again today and left it a bit longer to run. It seems there's a problem with border.

    INFO: Frame grabber created and started
    KODICHECK ERROR: Kodi Connection error (0)
    BORDER SWITCH REQUIRED!!
    CURRENT BORDER TYPE: unknown=0 hor.size=0 vert.size=9
    EFFECTENGINE INFO: effect finished..
    KODICHECK ERROR: Kodi Connection error (0)

    Edit: Strange, reinstalled it and works now... Closing the thread.
     
    Last edited: 7 November 2016