1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + OpenELEC Raspberry + arduino +ws2812b

Discussion in 'Software Support' started by drakengard, 26 May 2018.

  1. drakengard

    drakengard New Member

    Messages:
    4
    Hardware:
    RPi3, +Arduino
    Hi i have a problem , i have arduino and rpi3 and led strip ws2812b with 3 pin.
    what the version of osmc or openelec use? because the newer doesn't work. please help me to configure all to work with hyperion
     
  2. Jose Ramon Espericueta

    Jose Ramon Espericueta Member

    Messages:
    66
    Hardware:
    RPi3, +Arduino
    I have the march version and works fine i have the same hardware as you , maybe if you put your sketch and hyperion config someone can help you
     
  3. drakengard

    drakengard New Member

    Messages:
    4
    Hardware:
    RPi3, +Arduino
    could you tell me how you did it?
     
  4. Jose Ramon Espericueta

    Jose Ramon Espericueta Member

    Messages:
    66
    Hardware:
    RPi3, +Arduino
  5. drakengard

    drakengard New Member

    Messages:
    4
    Hardware:
    RPi3, +Arduino
    I finally did it. a little luckily. I noticed that the sketch I used did not work with this version of hyperion. so I found another one. now everything works, the only thing is that I am using a nano arduino with a bound of 500000, later I take arduino an r3. thank you so much and what sketch do you use?
     
  6. Jose Ramon Espericueta

    Jose Ramon Espericueta Member

    Messages:
    66
    Hardware:
    RPi3, +Arduino
    Excellent i use,The one thats its in the tutorial
     
  7. drakengard

    drakengard New Member

    Messages:
    4
    Hardware:
    RPi3, +Arduino
    Just a Little problemi . What cancellare i do for the Black line on bottom and dawn screen ? I try ti switch from NTSC ti pal but the result is the same
     
  8. Jose Ramon Espericueta

    Jose Ramon Espericueta Member

    Messages:
    66
    Hardware:
    RPi3, +Arduino
    Im not sure because i use a webcam as source an crop that part , maybe with blackborder detector part