Moin. Ich wühl mich jetzt seit ner Stunde durch die Foren und finde zig Lösungsansätze, die alle irgendwann mit "Klappt doch nicht richtig" oder...
My solution for this was simply using a master-slave power strip. It turns off all other power sources when my AV receiver turns off (so TV,...
Hast du mal nen Screenshot vom Grabber gemacht, um zu sehen, was der sieht? Du hast den internen Grabber aktiv, d.h. kann sehr gut sein, dass da...
Läuft bei mir einwandfrei. Ich benutze allerdings einfach ein fertiges Image mittlerweile. [MEDIA]
There are some splitters that can pass through 4k on one output while doing 1080p on the other. There are actually several discussions about this...
Default pin for SPI is pin 12 unless you also specified the gpio in the config, which your pasted example doesn't have.
Did you actually adjust your config file to the new LED type?
The Zero apparently has trouble directly controlling WS281x LEDs. Use an Arduino with Adalight in between and it'll work.
I use this method: https://learn.adafruit.com/read-only-raspberry-pi/overview Their "You can never ever undo this" is a bit misleading, though. If...
Did you try doing a fresh install from scratch?
The UTV007 has a very overexposed image.. unfortunately, the driver doesn't allow for correction commands. It may help to put a 75 ohm resistor on...
Die Seiten existieren gar nicht mehr, von denen der versucht, die Pakete zu laden. Installier das Ding direkt frisch, mit der neuesten Version.
Either works, but it'll still keep using power if not turned off fully. I use a master-slave plug that turns off the power to my whole AV system,...
You can probably test with a PC power supply if you have nothing else available. Alternatively, try disconnecting i.e. half of your LED strips and...
Your power supply may be junk then. If you can, try a different one.
Nein, nicht 100% sicher. Probier's ohne, und wenn es nicht will, dann nochmal mit den 3.3V.
Die 3.3V müssten ein Ausgang sein und sollten nicht benötigt werden.
Was genau "funktioniert nicht" bzw "nicht richtig"? Wenn die Farben richtig sind, aber an der falschen Stelle, dann hast du deine Start-LED an der...
Yep. "adalight" in hyperion and "fastLED" on the arduino.
I use a Pi Zero with ws2812b, with an arduino nano over USB. That works flawlessly. I had no luck on the direct connection either, if I recall right.
Separate names with a comma.
