My hardware setup is a 5m 300 LED WS2812b, rpi2, arduino nano, HDMI capture card, and I'm currently using a 5v 15a 75w power brick, 1000uf 25V...
Hello all, I am currently working on a prototype to add bias lighting to one of my televisions, and if all goes well, a template to build more...
I power my rpi3 and led strip with 1 power supply. But the thing is: I get the yellow electrical logo on the top of the display. I am using an...
Hi people, Does somebody have an idea how to power the RPI and the led strip with 1 power supply? I Know it is possible but I could not find the...
hi guys, I used for some months ambilight with my rpi3 When I open the pi the rainbow swirl is nice. When I want to watch a movie it is getting...
I am having difficulty calibrating HyperCon with my setup: RGB LED WS2812B connected to 5V-15A power supply and Data In connected to Pi Zero W...
Would it be possible to power the Pi & LED strip using the 5V USB port on most TVs? I am hoping to power the Pi Zero W through its mini USB port...
Hi people, I made an second ambilight for my family. When I test the led strip in my home with the pi 3b and 5v10A everything works fine. When...
Ok, so I put together my existing Hyperion setup 3 years ago, using WS2801s, on a 55" TV. Apart from a snap-on connector on one end of the strip,...
I have 94 LEDS on the WS2801 strip around my TV, and I have it all connected to my RPIZero, including the power, and it works. After some initial...
A couple weeks ago I noticed that Hyperion couldnt connect to the LEDs any more ("cannot connect to host" error message) but I was too busy to...
I have been doing some searching and can't really find a clear answer to this question. I have purchased ws2812b LEDs, 30/m. The power supply I...
I'm about to start putting together a Hyperion "Ambilight" setup. One of the things I forgot was a PSU for the LEDs. I am using 60LEDs per meter...
Separate names with a comma.