1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + Other Software Configuring Hyperion

Discussion in 'Software Support' started by left7, 3 November 2020.

  1. left7

    left7 New Member

    Messages:
    1
    Hardware:
    32/64bit, +nodeMCU/ESP8266
    I am at a loss. I followed the video by Dr. Zzz's


    I was never able to get Hyperion UI to display. Moved on from that install and found Hyperbian. With Hyperbian installed, I am able to get into the software. I am able to get the effects from Hyperion to run on my LEDs, but never able to get the video to preview in the LED visualization.

    A little about my setup.
    WLED reports to me that it is receiving data from Hyperion.

    I will gladly provide any logs or any other details necessary.

    Thank you in advance
     
  2. LosArtigah

    LosArtigah New Member

    Messages:
    14
    Hardware:
    RPi1/Zero
    I was having the same issue.
    Make sure you have enough power for your Pi and LEDs.
    I also noticed that under the capture configuration I had to enter the source device path (/dev/video0) instead of "automatic"

    -Los