1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + Other Software GPIO18 Pin not staying active

Discussion in 'Software Support' started by VickyS917, 26 November 2020.

  1. VickyS917

    VickyS917 New Member

    Messages:
    1
    Hardware:
    RPi3
    Evening all,

    I'm having issues with GPIO18 pin, when i switch the Pi on i have to go into putty and input the commands
    sudo systemctl disable --now [email protected] followed by
    sudo systemctl enable --now [email protected] to activate my leds, have i missed something in my setup to allow this to stay active or is there a command i can use to stop me having to log into putty everytime.

    TIA.