1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hdmi grabber?

Discussion in 'Hyperion General' started by pigbait, 30 December 2018.

  1. eviltrooper

    eviltrooper New Member

    Messages:
    14
  2. Hiruma31

    Hiruma31 New Member

    Messages:
    1
    Hardware:
    RPi3
    I bought the same hardware (VGB500 Grabber) and was about to send it back when I stumbled upon your message.
    I have the same setup: Raspberry Pi 4 and `hdmi_force_hotplug = 1` in /boot/config.txt.
    Raspbian Buster is fully up to date too.
    I tried installing hyperion.ng in its latest version, but can't seem to make the grabber detected.
    Would you mind sharing your config ?

    Edit: Actually managed to make it work :)
    I am not sure exactly what was the issue, I couldn't get the module uvcvideo, modprobe was throwing errors.
    I installed libuvc0-devel just in case.
    In the end, I rebooted the Raspberry and everything was detected properly.

    As far as my early tests went, it works perfectly with Kodi on one side and the PS4 on the other.
     
    Last edited: 1 December 2019