1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + LibreELEC [HowTo] Install Hyperion.ng on LibreELEC x86_64/RPi (inoffiziell/unofficially)

Discussion in 'Software Support' started by Paulchen-Panther, 19 March 2020.

  1. Rene Zuch

    Rene Zuch New Member

    Messages:
    26
    Hardware:
    RPi3, +PhilipsHue
    @Paulchen-Panther

    PR 1087 solves the problem with signal detection.

    Can you tell me how I could merge these fixes to the installed version? Is it just copying the files from PR 1087 to the hyperion folder or will it still run in debug mode then?

    Thanks
    René
     
    Last edited: 15 November 2020
  2. Paulchen-Panther

    Paulchen-Panther Moderator Staff Member Developer

    Messages:
    862
    Hardware:
    RPi1/Zero, RPi3, 32/64bit, +Arduino, +nodeMCU/ESP8266
  3. Rene Zuch

    Rene Zuch New Member

    Messages:
    26
    Hardware:
    RPi3, +PhilipsHue
    Already installed and running. Thx.

    René