1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

RPi + Other Software RPI3+HDMI Capture+HDMI Capture+Hyperion Alpha9

Discussion in 'Hardware Support' started by Sudip Roychoudhury, 27 December 2020.

  1. Sudip Roychoudhury

    Sudip Roychoudhury New Member

    Messages:
    4
    Hardware:
    RPi3
    I am trying to put together LEDs on back of my TV and this is the harsware I have
    1. RPI3 with Sandisk Ultra micro SD
    2. HDMI Capture Card - https://www.amazon.com/gp/product/B089KCSSZQ/ref=ppx_yo_dt_b_asin_title_o04_s01?ie=UTF8&psc=1
    3, WS2812B LED Strip - https://www.amazon.com/gp/product/B01CDTEJBG/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&psc=1

    Unfortunately I am not able to make the thing work. I can see the LED lights lightig up on Effects but it is not capturing the video and ligting up accordingly. I have had a minor success but it vanished suddenly.

    Can y'all suggest me if the hardware I am using is faulty and what all I should use for the purpose. Looking forward to y'alls suggestion
    Thanks
    SR
     
  2. lbk21

    lbk21 New Member

    Messages:
    6
    Hardware:
    RPi3
    I have a similar experience. I used the same hdmi capture card, but it turned on well at first, but now it's not responding.

    Now I bought another hdmi capture and connected it.
     
  3. jeroen warmerdam

    jeroen warmerdam Raspberry 3B / APA102 / Hyperion.NG relaisbox

    Messages:
    433
    Hardware:
    RPi3
    without the interferring of hyperion you can do it like this;


    to make a USB videostream on your PI vissible;
    open your terminal;


    sudo apt-get install mplayer

    then execute;
    sudo mplayer tv:// -tv device=/dev/video0 -hardframedrop



    after this a popup window will open with the videostream ( if its there) of /dev/video0

    goodluck
     
  4. flapman

    flapman New Member

    Messages:
    14
    Hardware:
    RPi3
    Assuming you wired everyting correct and WebUi is running try the following .

    Fault finding for external grabber:
    1. Does the internal grabber work in the preview window? No, jump to step 6; Yes, go to step 2
    2. Check Preview window with live video on (Button switch to green) -> No video, go to step 3; Yes go to step 6
    3. Check if USB record is active under Remote -> Yes, go to step 4; No, damn it switch it on. Repeat with Step 1 if still not working.
    4. Check if Rasp getting an Image, follow jeroen steps -> No, go to step 5;
    5. Check your equippment without the rasp by connecting them directly indepently on other Hardware like Laptop or different Tv/Screen. Hardware ok go to step 7

    Fault finding internal grabber
    6. Show LED and effects are visible in the preview? No, Check if you have set up the correct controller type in the LED Hardware setup window; Yes, go to step 7.
    7. Check your led set up, wires are wrong connected, faulty or no power supply or wrong conected on the rasp. Get a short strip working with effcets running, before installing the whole system.
     
    Last edited: 5 January 2021