1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ISSUE USB Capture Color Threshold no Effect

Discussion in 'Software Support' started by z3ky, 18 October 2020.

  1. z3ky

    z3ky New Member

    Messages:
    5
    Hi,
    I enabled the Signal Detection option in the USB Capture settings to set color thresholds. I try to reduce grabbed noise in black pictures. Red, green and blue thresholds seems to have no effects. The output to the LEDs doesn't change.
    Even with 100% thresholds the grabber forwards the detected colors to hyperion. No matter if it gets a black or colored picture.

    I run Hyperion 2.0.0-alpha.8. Same HW setup worked with the old Hyperion.
     
    Last edited: 18 October 2020
  2. Techguy

    Techguy New Member

    Messages:
    4
    Hardware:
    RPi3, +Arduino
    Are you doing a doing this on a 4k? also can you post your .json code to see what's going on.